Name: GeoVision GV-FD120D
Brand: GeoVision
Rating: 4 (1 reviews)

To Next Page

To Previous Page

20.2.3 PTZ Settings

Note this function is only available in PTZ Camera and PT Camera.

You can change the image settings, configure sequences, and access

settings including autopan speed, motor reset, digital zoom and system

default loading. For details, see Accessing the VISCA OSD Configuration

in 8.7.3 PTZ Camera Settings.

Figure 20-13

312

Default Chapter12
- Table of Contents12
- Naming and Definition23
- Device Description24
- Options24
- Note for Connecting to GV-System27
- Note for Recording28
- Note for Adjusting Focus and Zoom29
- Note for Installing Camera Outdoor30
- Note for Closing the Bullet Camera Cover32
- Note for USB Storage and Wifi Adapter33
Chapter 1 Introduction34
- System Requirement34
Chapter 2 Box Camera35
- Specifications37
- Packing List39
- Features40
  - Wide Dynamic Range Pro42
  - For GV-Ipcam H.264 Models that Support WDR, the WDR Effect Is Achieved through Software Programming42
- Overview43
- Accessory Installation51
  - C-Mount Lenses51
  - Infrared Illuminators (Optional)52
- I/O Terminal Block53
  - Pin Assignment53
  - Connecting to GV-Relay V2 (Optional)54
Chapter 3 Ultra Box Camera55
- Packing List56
- Features57
- Overview58
- Installation59
- Connecting the Camera61
Chapter 4 Target Box Camera62
- Packing List62
- Features63
- Overview64
- Installation65
- Connecting the Camera67
Chapter 5 IR Arctic Box Camera68
- Packing List69
- Features70
- Overview72
- Installation73
- Connecting the Camera77
- Wire Definition77
- Notice for Using the IR Arctic Box Camera79
- Enabling IR LED after Loading Default79
  - Disabling Status LED under Low Light Conditions80
Chapter 6 Mini Fixed Dome & Mini Fixed Rugged Dome81
- Packing List84
- Features85
- Overview88
- Installation95
  - GV-MFD Series95
  - GV-MDR Series97
- Connecting the Camera102
Chapter 7 Target Mini Fixed Dome105
- Packing List105
- Features106
- Overview107
- Installation108
- Connecting the Camera111
Chapter 8 Bullet Camera112
- Packing List114
- Features115
- Overview117
- Installation118
Chapter 9 Ultra Bullet Camera132
- Packing List134
- Features135
- Overview137
- Installation139
  - Connecting the Camera142
  - Waterproofing the Cable145
Chapter 10 Target Bullet Camera148
- Packing List148
- Features149
- Overview150
- Installation152
- Connecting the Camera155
Chapter 11 PTZ Camera157
- Packing List158
- Features159
- Overview160
- Installation162
- PTZ Control171
Chapter 12 PT Camera187
- Packing List187
- Features189
- Overview190
- Installation192
- Connecting the Camera192
- Focus Adjustment192
- I/O Terminal Block193
  - Pin Assignment193
  - Voltage Load Expansion (Optional)193
- PT Control194
Chapter 13 Vandal Proof IP Dome (Part I)196
- Packing List198
- Features199
- Overview201
- Installation203
Chapter 14 Vandal Proof IP Dome (Part II)214
- Packing List216
- Features219
- Overview221
- Installation223
- Connecting the Camera233
Chapter 15 Fixed IP Dome235
- Packing List237
  - Packing List for Hard-Ceiling Mount237
  - Packing List for In-Ceiling Mount238
- Features239
- Overview241
- Installation243
- Connecting the Camera253
- I/O Terminal Block254
- Pin Assignment254
- Voltage Load Expansion (Optional)255
Chapter 16 Cube Camera256
- Packing List257
Chapter 17 Advanced Cube Camera263
- Packing List264
- Features265
- Overview266
- Installation268
- Connecting the Camera270
Chapter 18 Getting Started271
- Accessing the Live View271
- Adjusting Image Clarity281
  - Using Focus Adjustment Cap284
  - Locations of Adjustment Screws285
- Configuring the Basics287
Chapter 19 Accessing the Camera288
- Accessing Your Surveillance Images289
- Functions Featured on the Main Page290
Chapter 20 Administrator Mode319
- Video and Motion322
- I/O Settings341
- Events and Alerts346
- Monitoring364
  - Monitoring Settings for Target Series365
- Recording Schedule366
  - Recording Schedule Settings366
  - I/O Monitoring Settings367
- Remote Viewlog368
- Network369
- Management380
Chapter 21 Recording and Playback394
- Recording394
- Playback395
Chapter 22 Advanced Applications404
- Upgrading System Firmware404
  - Using the Web Configuration Interface406
  - Using the IP Device Utility407
- Backing up and Restoring Settings409
- Restoring to Factory Default Settings411
- Verifying Watermark423
- Downloading Videos from the Micro SD Card426
  - Installing the GV-Sdcardsync Utility427
  - The GV-Sdcardsync Utility Window431
Chapter 23 DVR Configurations433
- Setting up an IP Camera440
  - Customizing IP Camera Settings443
- Remote Monitoring with Multi View445
  - Connecting to the IP Camera445
- Remote Monitoring with E-Map446
  - Creating an E-Map for the IP Camera446
  - Connecting to the IP Camera448
Chapter 24 CMS Configurations449
- Center V2449
- Vsm452
- Dispatch Server453
Chapter 25 Smart Device Connection455
Appendix456
- Settings for Internet Explorer 8456
- Supported Lenses for Box Camera457
- Resolution and Frame Rate458
- Support Lists464
- RTSP Protocol Command470
- The CGI Command471
- Dual Stream Support List473
- Power Supply Support List476
- Supported Firmware for Flash Memory477
- Specifications478

GeoVision GV-FD120D User Manual

Table of Contents

Other manuals for GeoVision GV-FD120D

Questions and Answers:

GeoVision GV-FD120D Specifications

Related product manuals

Brand	GeoVision
Model	GV-FD120D
Category	Security Camera
Language	English