Figure 1-2b
No. Name Function
6 Ready LED Shows the system status of the camera. See the table below.
7 Power button
Presses for around 10 seconds to turn/off the power.
Presses twice rapidly to enter into Access Mode to enable local
network access.
8 Network Status LED Shows the LAN status of the camera. See the table below.
9 Docking port
Connects GV-OPAL S1 to your bottom battery docking. See 1.3.2
Bottom Battery docking.
10 Default Resets the camera settings to factory defaults.
11 Memory card slot Inserts a micro SD card to store recording data.
LED Status Action Description
Showing orange/green
momentarily.
At camera startup.
Blinking green every other few
seconds.
The camera is powered on.
Solid red
You have pressed the Power button
for around 10 seconds before the
camera is powered off.
Ready
Blinking red every other few
seconds.
The camera is running out of power.
Fast blinking blue
The camera is attempting to connect
to WiFi.
Slow blinking blue The camera is in Access Point mode.
Fast blinking blue for 3 times at
regular interval
The camera loses WiFi connection.
Network
Status
Solid blue The camera is connected to WiFi.
4
To Next Page
Loading...
Need help?
General
