10
1.6 Loading Factory Default
If for any reason the camera is not responding correctly, you can reset it to its factory default
settings.
1. Keep the power adapter connected to the camera.
2. Use a pointy object such as the tip of a pen to hold down the Default button.
Figure 1-10
3. Release the Default button when the Network status LED shows fast blue blinking
.
This shall take about 3 to 5 seconds.
Figure 1-11
4. When the Network status LED stops blinking, the process of loading default settings is
completed and the camera reboots automatically.
To Next Page
Loading...
Need help?
General
