60 GS750
plus
11. Reinstall the cover.
12. Load paper in the plotter. Run a multiple line test plot.
13. Turn off power at the plotter.
14. Power-up the plotter while holding the RESET key. Load
paper and install pen holder.
15. Press the left arrow key to access the Wagon Wheel Test
Plot. Press either Run key to plot. Inspect your test plot by
comparing to the Wagon Wheel Test Plot illustration.
16. Turn off power at the plotter.
17. Power-up the plotter while holding the RESET key. Load vinyl
and install knife holder.
18. Press the SLOW key to access the Square/Circle Test Plot.
Press either Run key to plot. Inspect your test plot by
comparing to the Square/Circle Test Plot illustration.
19. If symptoms persist, return to step 1 or contact the Gerber
Field Service Department at 800-828-5406 or fax at 2033-645-
2448.
To Next Page
Loading...
