Gesipa PH 2 - Intended Use of Blind Rivet Setting Tool; Blind Rivet Setting Tool Safety Precautions

18
GB
1. Use for intended purpose
2. Safety information
As described in these operating instructions, the blind rivet setting tool may only be used for the
purpose of setting blind rivets.
Observe the safety information!
• The blind rivet setting tool is to be used solely for the purpose of setting blind rivets.
• Never overload the tool; work within the specied working capacity.
• Do not use tool without material! The blind rivet could be ung from the device! Never turn
the tool towards yourself or towards other persons.
• Regularly check the compressed air lines to ensure they are tted correctly and airtight.
• When carrying out maintenance work on the blind rivet setting tool and when the tool is not
in use, it should always be disconnected from the compressed air network.
• When working with the blind rivet setting tool, always wear protective goggles. Personal
protective equipment such as protective clothing, gloves, safety helmet, non-slip footwear,
ear protection and fall arresting device is recommended.
• The spent mandrel container must remain screwed on or attached during tool operation.
• Do not exceed the specied operating pressure for the tool.
• Dispose of the used hydraulic oil in accordance with valid environmental protection
regulations.