22 -
THE PROCESS
PROCESS START : 08:01:36 NEG. PULSE 3
AUTOCLAVE NAME : HS6613-2 POS. PULSE 5
AUTOCLAVE NUMBER : 1 STERILIZING TEMP134.0 C
CYCLE COUNTER : 5 STERLIZING TIME 00:07:00
DRYING TIME 00:05:00
DRYING STEAMPULSE 00:00:00
DRYING AIRPULSE00:00:00
PROGRAM: P1 POROUS LOAD 134
-----------------------------------------------------------------------------------------------------------------------------------------
CHAMBER PRESS DRAIN TEMP
7
1 In the top part, the date and time when the process was
started and the type designation, number and cycle coun-
ter of the sterilizer are shown.
2 Parameters of the current program that can be changed
with a parameter code are listed under PARAMETERS.
In this example, sterilizing temperature in °C and times
for various sub-processes in hours, minutes and seconds.
3 The parameters chosen for printing are listed under
SIGNALS.
4 Information about which program has been started, fol-
lowed by process logging.
5 Printed out if an error occurs during the process.
6 These lines are printed out after a faulty process. Identi-
fication code of the person who entered the password and
a line for a signature.
7 Graphical representation of the process
To Next Page
Loading...
