Getinge Maquet SERVO-i - Page 30

• Connect the O
2
cell connector.
• Put the O
2
cell in position.
• Close the locking catch.
3.3.3 Assembling
SERVO-i
• Put the cover in position.
• Tighten the bayonet screw.
SERVO-i
• Angle up the handle and push it down in
position.
• Perform a Pre-use check, see SERVO-i
User's Manual.
SERVO-s
2
• Push the cover in position.
• Tighten the screw.
• Perform a Pre-use check, see SERVO-s
User's Manual.
30
SERVO-i/s, User's Manual
| 3
| Maintenance |