Getinge Volista - Page 40

6
Inspections
Mechanical inspections
40 / 56
Maquet Volista
NM 01780 EN 03
Fig.45: Suspension arm
• Check the presence of the tube suspension’s linking screws and the replacement periodicity.
(Do not re-tighten these screws during maintenance as there is a risk of fracture. If screws
appear loosened, replace them).
• Check that the adjustment of the brake screws has been performed.
• Check the presence of the safety rings with holding screw.
• Check the presence of the bumpers and caps.
WARNING!
Risk of injury
The metal half-rings can be sharp.
The metal half-rings on the spring arm should be handled with care to avoid
any risk of cuts.
Fig.46: Acrobat or Ondaspace spring arm
• Check that the top stop is properly adjus-
ted.
• Check the balance.
• AC2000: Check the presence of the snap
ring and the replacement periodicity for the
DF version, and the presence of the two
stop screws for the SF version.
• AC2000 DF and SF: Check the presence
of the safety ring with holding screw.
• ONDASPACE SF: Check the presence of
the snap ring and the replacement period-
icity.
• ONDASPACE SF: Check the presence of
the safety ring with holding screw.
• Check the correct installation of the cov-
ers, the tightening of the screws for the
round covers.
• Check the condition, position and sliding of
the tabs.