Getinge Volista - Page 41

Inspections
Mechanical inspections
6
Maquet Volista
NM 01780 EN 03
41 / 56
Fig.47: Oasys spring arm
• Check that the top stop is properly adjus-
ted.
• Check the balance.
• OASYS DF: Check the presence of the
snap ring and the replacement periodicity.
• OASYS SF: Check the replacement peri-
odicity of the 2 snap rings.
• OASYS DF: Check the presence of the
safety ring and cover with holding screw.
• OASYS SF: Check the presence of the
safety ring with holding screw.
• Check the correct installation of the cov-
ers, the tightening of the screws for the
round covers.
• Check the condition, position and sliding of
the tabs.
Fig.48: Valia spring arm
• Check that the top stop is properly adjus-
ted.
• Check the balance.
• VALIA DF: Check the presence of the
snap ring and the replacement periodicity.
• VALIA SF: Check the replacement period-
icity of the snap ring.
• VALIA: Check the correct installation of
the covers, flanges, and the tightening of
the screws.
• VALIA: Check the presence of the flange
covers and screw covers.
• Check the position and sliding of the tabs.
Fig.49: Lighthead
• Check that the silicone covers, seals and cover are secure.
• Check that there are no cracks or scratches on the underside.