EasyManuals Logo

Getinge WD15 CLARO Technical Manual

Getinge WD15 CLARO
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Error
code
Error Note
A30 High temperature in
wash chamber
The temperature in the chamber is more than 5°C above the
highest reference point.
A31 External communication
error
DS30 Netcom is selected and communication with Netcom is
not
working. (If SF215 is set.)
Possible action:
a. Check the cabling.
b. Check the settings
A32 Log error DS30 Netcom is selected and the log is not working. (If SF217
and
SF218 are not set 2 min. after end of process.)
Possible action:
a. Check the USB memory stick
b. Check the settings
A33 Low disinfection
temperature
The temperature in the wash chamber is below the set value
for disinfection
(for a period longer than 60 seconds).
Possible action:
a. Check that there is power on all phases up to the
elements.
b. Check the calibration of the temperature sensors
4 ALARM MANAGEMENT
TECHNICAL MANUAL GETINGE WD15 CLARO 59 (128)
<Doc_TEC><Doc_6001396902><Rev.I><Lang_en>

Table of Contents

Other manuals for Getinge WD15 CLARO

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Getinge WD15 CLARO and is the answer not in the manual?

Getinge WD15 CLARO Specifications

General IconGeneral
BrandGetinge
ModelWD15 CLARO
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals