Getinge WD15 CLARO Technical Manual

3.5 DIP switches
DIP switches allow you to turn various functions on or off. A
Supervisor or higher level password is required to change DIP
switches.
DIP switch Option Description
DS00 DW WATER There is a water valve for treated water on the machine.
DS01 CONDENSER There is a condenser on the machine.
DS02 DRAIN COOLING Drain cooling available on the machine.
DS03
WATER SOFTENER
There is a salt filter on the machine.
DS04 DETERGENT 3 Dosing pump 3 available on the machine.
DS05 DETERGENT 4 Dosing pump 4 available on the machine.
DS06 FLOW CONTROL 1 Flow monitoring for dosing pump 1 on the machine.
DS07 FLOW CONTROL 2 Flow monitoring for dosing pump 2 on the machine.
DS08 FLOW CONTROL 3 Flow monitoring for dosing pump 3 available on the
machine.
DS09 FLOW CONTROL 4 Flow monitoring for dosing pump 4 available on the
machine.
DS14 PRINT MAX/ MIN Max and min. values are printed in log.
DS15 SERVICE MESSAGES Service messages activated.
DS17 NETCOM NetCOM is installed on the machine (logging to USB
memory stick).
DS26 REGEN DISABLE Disable regeneration when soft water is used.
DS28 A0-CONTROL The disinfection process is controlled with A0 value.
DS29 A0-PRINT Calculated A0 value is printed in log.
DS30 PC DISK LOG NetCOM is installed on the machine (only T-DOC, no USB
memory stick).
DS31 LOOP RUN The machine is in loop run mode (only for tests).
3 MENU TREE
TECHNICAL MANUAL GETINGE WD15 CLARO 49 (128)
<Doc_TEC><Doc_6001396902><Rev.I><Lang_en>

Getinge WD15 CLARO Specifications

General

Brand	Getinge
Model	WD15 CLARO
Category	Laboratory Equipment
Language	English