Getinge WD15 CLARO Technical Manual

5.1.1 Service table
Activity/Component
Inspection/Replacement
Every year
/7500 cycles
Every other
year
/15000
cycles
Time
required
1 General
1.1 5.3.1 Checking electrical cables and connection
points 1.1
• 10 min
1.2 5.3.2 Checking the cooling fan 1.2 • 5 min
1.3 5.3.3 Checking the panel 1.3 • 2 min
1.4 5.3.4 Checking the machine is level 1.4 • 5 min
1.5 5.3.5 Checking the Quick guide 1.5 • 1 min
1.6 5.3.6 Checking error codes and number of
processes 1.6
• 2 min
2 The chamber
2.1 5.4.1 Clean the inside of the chamber 2.1 • 20 min
2.2 5.4.2 Check the spray arms 2.2 • 20 min
2.3 5.4.3 Replacing spray arm bearings 2.3 • -
2.4 5.4.4 Checking temperature sensors 2.4 • 10 min
2.5 5.4.5 Checking the strainer in the bottom of the
chamber 2.5
•
2.6 5.4.6 Checking insert for goods 2.6 •
2.7 5.4.7 Checking the wash cart guide rails 2.7 •
2.8 5.4.8 Checking the salt level in the salt filter
(Option) 2.8
• 10 min
3 Door
3.1 5.5.1 Checking door and door springs 3.1 • -
3.2 5.5.2 Checking the door seal and chamber seal
3.2
• 5 min
3.3 5.5.3 Checking the door lock and switch for proper
functioning 3.3
• 10 min
3.4 5.5.4 Checking the door wire 3.4 • 5 min
4 Connections
4.1 5.6.1 Checking water and drain connections 4.1 • 5 min
4.2 5.6.2 Checking the filter for incoming water 4.2 • 10 min
5 Dosing system
5.1 5.7.1 Checking hoses 5.1 • 5-10 min
5.2 5.7.2 Replacing a hose to a hose pump 5.2 • 10 min
5.3 5.7.3 Checking the dosing amount 5.3 • 10-30 min
5.4 5.7.4 Checking the empty container alarm 5.4 • 5 min
6 Dryer
6.1 5.8.1 Replacing a HEPA filter 6.1 • 10 min
6.2 5.8.2 Checking fan function 6.2 • 5 min
5 PREVENTIVE MAINTENANCE
TECHNICAL MANUAL GETINGE WD15 CLARO 61 (128)
<Doc_TEC><Doc_6001396902><Rev.I><Lang_en>

Getinge WD15 CLARO Specifications

General

Brand	Getinge
Model	WD15 CLARO
Category	Laboratory Equipment
Language	English