too low you may not be able to get fully closed Hi-Hat Sounds, even if the cymbals are in closed
position with a good amount of pressure on the Hi-Hat Pedal.
Low Position Parameter Value Range: 0-127
11.3.1.9 CHICK SENSITIVITY (HI-HAT PEDAL ONLY)
Measured against CC MIDI message value: 0 - for fully open, 127 - for fully closed. Set the level
below which a following pedal 'step on' will generate a chick.
Chick Sensitivity Parameter Value Range: 0-127
11.3.1.10 PEDAL CALIBRATION (HI-HAT PEDAL ONLY)
This function sets the values for Low Position and High Position by using a calibration wizard. Instead
of trying out different values individually, this guided process will be especially useful in conjunction
with 3
rd
party equipment, providing a good first estimate about the value range in which the
equipment operates. Since Low Position refers to a closed position with maximum pressure and
limited musical application, the routine will automatically define the closed position with less pres-
sure at an offset of 15% above the determined Low Position value. After the calibration, some minor
manual adjustments of the Low Position parameter might be necessary to compensate characteris-
tics of different gear ratios between pedal and the Hi-Hat rod.
The following table explains the calibration wizard:
To Next Page
Loading...
