Instruction manual Installation
15
8.5.2 Apply sound-conductive paste
Using the syringe, apply sound-conductive paste (3) to the sensor contact surfaces (1)
and (2).
8.5.3 Mounting the guide rail
Mount the guide rail (1) and pipe adapters if necessary (see section 8.5.1 Selecting the
pipe adapter) on the pipe (3) using the pipe clamps (2).
Loosen the mounting screws and remove along with the washers.
Store the mounting screws and washers away for future maintenance work or for a possible
change of position later.
To Next Page
Loading...
