GF U1000 V2 - 14 Removal; 15 Disposal

Instruction manual Removal
35
Receiver
Comments
Address
Command
Error code
CRC-16
[1 byte]
[1 byte]
[1 byte]
[2 bytes]
0x01
0x03
None
n/a
n/a
Example of a good message
0x01
0x8C
0x01
0x85
0x00
The only acceptable commands are 0x03 and 0x06
0x01
0x83
0x02
0xC0
0xF1
Incorrect register start
0x01
0x83
0x03
0x01
0x31
Incorrect register length
0x01
0x83
0x06
0xC1
0x32
slave is busy processing and is unable to respond
0x01
0x83
0x07
0x00
0xF2
CRC is incorrect
14 Removal
 Switch off the external power supply and prevent it from being switched on again.
 Disconnect all cable connections.
 Loosen the pipe clamps and remove the U1000 V2 completely from the pipe along with all
connecting cables.
15 Disposal
 Before disposing of the different materials, separate them into recyclable materials,
normal waste and special waste.
 Comply with local legal regulations and provisions when recycling or disposing of the
product, individual components and packaging.
 Comply with national regulations, standards and directives.
A product marked with this symbol must be taken to a separate collection point
for electrical and electronic devices.
If you have any questions regarding disposal of the product, please contact your
national agent for GF Piping Systems.