Installation Instruction manual
16
8.5.4 Install the electronics module
Connect the power supply (1) to the electronics module (2).
Plug the cables of the two sensors into the sockets (3) and (4) on the electronics module.
The cables can be assigned as desired.
Set the electronics module (1) on the guide rail (2) and engage it in the clamp connections
at both ends.
8.6 Moving the guide rail
If it becomes necessary to change the position of the guide rail or the sensors:
Remove complete assembly from the pipe.
Undo the screw at the end of the guide rail and gently lift the same end as shown.
The opposite end of the electronics can now be released from the guide rail.
Disconnect the sensors.
Remove the original Gel pads from the sensors.
To Next Page
Loading...
