Instruction manual Password-protected menus
23
9.5 Switching off and on again
If the power supply is switched off and then on again after the pipe inside diameter is entered
for the first time, then the last applied configuration is used.
If the configuration is changed for some reason, the password-protected menu must be used.
See Section 10 Password-protected menus, Page 23.
10 Password-protected menus
10.1 Overview
Password-protected menus allow the preset values to be adapted as required:
To change the dimensions from mm to inches or vice versa
To change from volume flow to flow rate measurement
To change between system units l/m
3
or Impgal/USgal
To change between flow units l/s, l/min or gal/s, gal/min or USgals/s, USgals/min
To change the preset value for flow at maximum current
To change the preset value for flow at minimum current
To change the type of pulse output
To change the pulse output parameters
Press the button.
You are prompted for the password.
If the password is not entered, the display automatically changes back to the
flow value after a few seconds.
Enter the password (71360).
See Section 10.4 Changing the numerical values in data menus, Page 24.
To Next Page
Loading...
