Instruction manual Intended use
3
1 Intended use
The U1000 V2 ultrasound flowmeter is used to obtain an optimal measurement of the volume
flow and flow rate in steel and plastic pipes with outside diameter from 22 mm (0.86”) to 180
mm (7”).
Measurable pipe sizes are dependent on pipe material and inner pipe diameter.
Typical applications
Hot water metering and flow measurement
Flow measurement and heat measurement
Cold water metering and flow measurement
Tap water metering and flow measurement
Service water metering and flow measurement
High-purity water metering and flow measurement
2 About this document
This document contains all the information necessary for installation, operation and
maintenance of the product.
2.1 Warnings
This instruction manual contains warning notices that alert you to the possibility of injuries or
damage to property. Always read and pay attention to these warnings!
Risk of fatal or serious injury!
There is a risk of fatal or serious physical injury if warnings are ignored!
Danger of minor physical injury!
Failure to pay attention to these warnings will lead to a risk of physical injury!
Risk of damage to property!
Failure to comply leads to a risk of damage to property (loss of time, loss of data, device
fault etc.)!
To Next Page
Loading...
