GFA TS 959 - Mains Supply

14

Run the connection cable through the housing
and insert the plugs.
 Tighten the cable gland.
NOTICE
Damage due to moisture or penetrating foreign bodies
 Check that all cable glands are tight.
 Seal open and unused cable entries with blanking plugs. This will prevent moisture or foreign bodies
such as insects from penetrating.
7 Connecting external devices
WARNING
Danger to life from electric shock!
Improper wiring may result in severe or fatal injury from electrical current.
 Allow only qualified electricians to carry out the work.
 Disconnect all cables from the power supply.
 Secure the mains disconnector against plugging in or switching it on again.
 Observe valid regulations and standards.
 Use suitable tools.

Check the insulation of cables and make sure that cables outdoors are protected.
i
NOTE
The inputs of the following safety devices of the control are rated Performance Level c (PLc):
 Slack-rope switch
 Pass-door switch
 Safety edge
 Limit switch system
 Safety circuit of the drive unit

Emergency STOP
control device
i
NOTE
Connect only sensors that comply with the current EN 12453 and are suitable for
Performance Level c.