Always use the oil as described in chapter “Maintenance”, never mix-
ture with oils of other kinds. This causes damage to the engine.
Replace engine oil
• Warm up the engine, engine
oil temperature > 80
ºC
(>176
ºF).
• Place the engine in a hori-
zontal level position.
• Switch off the engine.
• Place a collecting receptacle
underneath the engine oil
drain plug (C).
• Unscrew the engine oil drain
plug (C).
• Wait until the crankcase is
completely empty.
• Reinstall the engine oil drain
plug. Always use a new seal-
ing ring (S). Tightening
torque = 55 Nm (41 lbf.ft).
• Open the oil filler cap (A) and
fill up with new engine oil.
(see chapter liquids for oil
specifications).
• Close the oil filler cap, warm up the engine, engine oil temperature > 80
ºC
(>176
ºF).
• Perform engine oil level check. Check for leakage and add oil if necessary.
To Next Page
Loading...
