76
6.Commissioning
FIRST INSPECTION
• Before use, remove the articulation lock bar (transport
protection).
• The Wheel Loader is powered by a diesel engine. This
engine is equipped with an electric starter.
• Always check the oil levels before you start (see sec-
tion ‘Maintenance’).
• Make sure the fuel tank contains sufficient fuel.
• Beware of fire! Stay away from the fuel tank with cigarette lighter, match or
other spark-inducing items. Keep the articulated loader free of combustibles.
• The Wheel Loader is top heavy and tilt sensitive. Especially with the loaded
tool in the upper position. Make sure the centre of gravity of the load to be
lifted is in the middle of the tool. Note that the ground under the Wheel Loader
is sufficiently load bearing and flat.
• Contact your dealer in case you have any questions.
IGNITION SWITCH
Never press the accelerator all the way when you start. This causes
damage to the engine.
A. Stop engine.
B. Contact on.
C. Glowing (preheating, spring loaded).
D. Start engine (spring loaded).
E. Parking (unused).
Starting order:
1. Check whether the direction switch is set
to neutral.
2. Turn the ignition switch to position C and
hold this for about 5 seconds.
3. Turn the ignition switch to position D and
hold this position until the engine has
started.
4. Release the ignition switch; it will return to position B (contact on).
To Next Page
Loading...
