Check only with the Wheel Loader on a level surface and the engine is
turned off for at least 3 minutes. The oil level should be between the
markers. Refill if needed.
Adding engine oil
• Pull out the oil level dipstick
(B) and clean it with a lint-
free, clean cloth,
• Reinstall the oil level dipstick
in the oil level pipe,
• Pull out the oil level dipstick
again and measure the oil
level (MIN - MAX),
• Oil level must be between the
MIN and MAX markings,
• If the oil level is to low,
remove the oil filler cap (A)
and fill with recommended oil
to the upper level mark,
• After adding oil, wait for more
than five minutes. It takes
some time for the oil to come
down to the oil pan,
• Pull out the oil level dipstick again and measure the oil level.
To Next Page
Loading...
