104
7.Maintenance
Replace oil filter
1. Place a collecting receptacle underneath
the engine.
2. Loosen and unscrew the engine oil filter
(C) with a filter wrench (F).
3. Collect draining lubricating oil in a
collecting receptacle.
4. Clean the sealing surface of the filter
support with a lint-free, clean cloth.
5. Oil the gasket of the new GIANT original
filter cartridge (S) lightly (Do not use
grease).
6. Fasten the new filter by hand until the
gasket touches the oil filter support.
Fasten with a torque of approximately 12
Nm (9 lbf.ft) hand tight.
7. Open the oil filler cap (A) and fill up with
new engine oil. (see chapter liquids for
oil specifications).
8. Perform engine oil level check. (see
replace engine oil).
FUEL
Standard diesel fuel according to one of the following technical specifications:
•EN590
• ASTM D975 2D
• JIS K 2204
HYDRAULIC OIL
Add or replace hydraulic oil.
• See chapter “commissioning”
The standard hydraulic oil used has viscosity class “VG 46”
. Change the type of
hydraulic oil according to the (average) ambient temperature:
above 25°C (77°F) VG 68
0°C to 25°C (32°F to 77°F) VG 46
below 0°C (32°F) VG 32
To Next Page
Loading...
Need help?
General
