Only drive on slopes when the loader attachment is empty. In the
event that the wheel loader should drive on a slope, the maximum
slope angle is 11.3º (20%).
1. Get on and off safely when entering or leaving the operator’s cab. Face the
machine. Always maintain a three point contact with the steps and handrails.
Do not use control levers as handles. Do not jump on or off the machine.
Never try to get on or off a moving machine.
2. Do not start engine or operate levers from anywhere other than the seat.
3. Before starting the engine, fasten the seat belt, make sure that the direction
lever is set in the neutral position, the parking brake switch is actuated and the
bucket is lowered to the ground.
4. Do not start engine by shorting across starter terminals.
5. Watch where you are going at all times. Watch for and avoid obstacles.
6. Never permit passengers on the machine. Keep bystanders away from the
machine during operation.
7. When working around other machines, let the other operators know what you
are doing at all times.
8. Never allow anyone to get under or near the bucket or attachment when it is
raised.
9. When raising the bucket or attachment, take extra caution to prevent it from
touching overhead wires or other obstacles. Contact with wires may cause
fatal injuries.
10. Keep away from the muffler while the engine is running and immediately after
it has stopped.
11. Hazardous operation such as on dangerous terrain, beyond the load capacity
or contrary to the intended use of the machine must be avoided as it may
cause the machine to tip over.
12. Do not drive the machine close to edges of ditches or banks which may
collapse under the weight of the machine, especially when the ground is loose
or wet.
13. Slow down for turns, uneven terrain and slopes to avoid tipping over.
14. When transporting a load, keep the loader bucket as low as possible to avoid
tipping over. Be extremely careful when working on inclines.
15. Operation on slopes can be dangerous. Rain, snow, gravel soft ground, etc.
will change the surface conditions. Do not operate the machine in questiona-
To Next Page
Loading...
Need help?
General
