Giant D332SWT User Manual

32
4.Safety
During Operation
• ALWAYS fasten the seat belt securely and properly. Never operate the
machine without the seat belt fastened around the operator.
• Check indicators and displays for normal conditions after starting the engine.
Listen for unusual sounds and remain alert for other potentially hazardous
conditions.
• Control the machine cautiously and gradually until fully familiar with all the
controls and handling.
• Do not overload the machine. See chapter “Technical data”.
• Do not raise or drop a loaded bucket or attachment suddenly. Abrupt move-
ments under load can cause serious instability.
• Check that attachments are securely fastened to the attachment hitch before
working.
• Never activate the float function with the bucket or attachment loaded or
raised, because this will cause the lift arm to lower or bucket to dump rapidly.
• Never operate the machine without a ROPS or FOPS installed.Machine stabil-
ity is affected by: the weight of the load being carried, height of the load,
machine speed, turn angle, width of the machine across the tires, abrupt con-
trol movements and driving over uneven terrain.
DISREGARDING ANY OF THESE FACTORS
CAN CAUSE THE MACHINE TO TIP, THROWING
THE OPERATOR OUT OF THE SEAT OR
MACHINE, RESULTING IN DEATH OR SERIOUS INJURY.
Therefore: ALWAYS operate with the seat belt fastened around the operator.
• Do not exceed the machine's rated operating capacity; see chapter “Technical
data”. Be aware that effective operating capacity is reduced when the machine
is turned.
• Machine stability is reduced when the machine is turned.
• Be aware that attachments effect the handling and balance of the machine.
Adjust the operation of the machine as necessary when using attachments.
• Carry the load low. Move the controls smoothly and gradually, and operate at
speeds appropriate for the conditions.
• Do not use the machine to lift or transport people. Do not allow others to ride
on the machine or attachments, because they could fall or cause an accident.
• Always look to the rear, over both shoulders, before backing up.
• Only start the engine while seated in the operator's seat with the seat belt fas-
tened around the operator.
• Only operate the controls while seated in the operator's seat with the seat belt
properly fastened.
• Always keep hands and feet inside the operator's compartment while operat-
ing the machine.
WARNING

Giant D332SWT Specifications

General

Brand	Giant
Model	D332SWT
Category	Compact Loader
Language	English