Gigaset C2 - Page 119

116
System settings
S1_SL1 / englisch / A31008-X150-B103-1-7619 / settings_bs.fm / 02.10.2003
Activating/deactivating internal call forwarding
Precondition: Internal call forwarding can only be activated if the forward destination
is set up.
Defining the number of rings
When ring delay is used, the number of rings before the call is forwarded must be
defined. Between 0 (= immediate call forwarding) and 9 rings can be set. There are
5 seconds between rings.
The factory default setting is 0 rings (= immediate call forwarding).
Forwarding external calls – CF (Call Forwarding)
For each receive MSN you can store a destination number for each of the following con-
ditions:
Immediately – On busy – On no reply
Set up external call transfers are entered in a list. Active call transfers are identified in
this list.
When the phone is supplied external call forwarding is not set.
v
Open the menu.
s Base Settings
Select the menu item and confirm.
s Int. call forw.
Select the menu item and confirm.
~
Enter system PIN if required (page 91).
either ...
Activate:
Activate?
Confirm.
or ...
Deactivate:
Deactivate?
Select the menu item and confirm.
OK
OK
OK
OK
OK
v
Open the menu.
s Base Settings
Select the menu item and confirm.
s Forward. base
Select the menu item and confirm.
~
Enter system PIN if required (page 91).
s No. of rings
Select the menu item and confirm.
~
Enter the number of rings and confirm.
a
Hold down (return to idle status).
OK
OK
OK
OK
OK
i
◆ If call forwarding is sent to the base station (internal) (page 119), the
condition On busy is not available.
◆ All three conditions can be activated at the same time.
◆ If Night service was set up for an incoming MSN (page 98), external
call forwarding cannot be set up or changed for this incoming MSN.