Gigaset C2 - Setting the Answering Machine; Assigning a Receive MSN

62
Setting the answering machine
C1-C2 isdn / englisch / A31008-X150-B103-1-7619 / answeringm_config.fm / 19.11.2003
Setting the answering machine
Once you have connected your telephone your answering machine is ready for use.
Answering machine AM1 is set to be shown and activated. It displays all messages (on
all receive MS's). AM1 can be played back and set from all handsets (factory default). All
phrases in the answering machine are in English.
As supplied, AM2 and AM3 are hidden (page 63) and are deactivated. To use them, they
must be shown, and all answering machines shown must be assigned their own receive
MSN.
You can configure AM1, AM2 and AM3 separately.
Assigning a receive MSN
You can assign one or more receive MSNs to each (shown) answering machine (AM1,
AM2, AM3). However, each MSN can only be assigned to one answering machine (only
one recording can be running at any one time).
Once an answering machine has been assigned to a receive MSN it can only be set and
operated via handsets/terminals to which the same receive MSN is assigned.
at the base:
CX150isdn SX150isdn CX253isdn SX255isdn SX353isdn
MENU
Open the menu.
s Base Settings OK
Select the menu item and confirm.
s Settings OK
Select the menu item and confirm.
s Setup user OK
Select the menu item and confirm.
Setup device OK
Confirm.
s
Select answering machine, INT 91: AM 91 for AM1,
INT 92: AM 92 for AM2 or INT 93: AM 93 for AM3.
MENU
Open the submenu.
s Receive MSN OK
Select the menu item and confirm.
s OK
Select the receive MSN and confirm, e.g. MSN:
Anna. Only the MSNs that are still not assigned to an
answering machine are offered.
Repeat this procedure for all receive MSNs that you
wish to assign to the answering machine.