Gigaset N720 DECT IP User Manual

12
First steps
Gigaset N720 DECT IP Multicell System / engbt / A31008-M2314-L101-2-7619 / starting.fm / 06.02.2012
Version 2, 06.08.2010
Connecting base stations and DECT Manager
To be able to make calls with your Gigaset N720 DECT IP Multicell System via VoIP, the
following conditions must be fulfilled:
u The DECT Manager is installed
u Your DECT Manager and base station are connected to the local network (£ page 14)
u At least one base station is registered (£ page 17)
u At least one handset is registered to the telephone system (£ page 18)
Perform the following steps in the specified sequence, first for the DECT Manager and
then for all the base stations to be installed:
§§1§§ Connect the power cable to the device and connect to the mains power supply, if
necessary.
§§2§§ Connect the base to the router/switch to access the local network and configure via
the Web configurator.
§§3§§ Fix the device to the planned position on the wall.
Please note
Your Gigaset N720 DECT IP Multicell System is supplied with sufficient power via PoE
(Power over Ethernet) if the device is connected to an Ethernet switch with PoE
functionality (PoE class IEEE802.3af). In this case, you do not need to connect the
device to the mains power supply and step
§§1§§ can be omitted.

Gigaset N720 DECT IP Specifications

General

Brand	Gigaset
Model	N720 DECT IP
Category	Telephone Accessories
Language	English