requirement, then the monitor could finish the collection according to the setting.Parameter
explanation is as follows:
Patient Name: the patient's name
Patient ID: the patient's ID number.It is used for marking patient, and it is exclusive in order to
avoid homonymy patient arisen state
Current Time: Current system display time
Time Periods:
Awake Time: the patient is awake state
Asleep Time: the patient is asleep state
Interval: collection Interval.In order to reduce the effect to the patient sleep, the asleep collection
interval should be longer.
For example as above figure:the awake time area is 7:30-22:30, and the asleep time area is
22:30-tomorrow7:30. The awake collection interval is 30 minutes, and the asleep collection interval
is 60 minute.
The asleep time area and awake time area will be display at the right side.
When the parameter setting is finished, click " Okay " to upload the project to the monitor.
To Next Page
Loading...
