screen or no display content, please contact our company.
Note
The software was developed in accordance with IEC60601-1. The possibility of hazards
arising from errors in the software program has been minimized.
All analog and digital equipment connected to this device must be certified to IEC
standards(such as IEC60950: Information technology equipment-Safety and IEC60601-1:
Medical electrical equipment-Safety), and all equipment should be connected to in accordance
with the requirement of the valid version of the IEC60601-1-1 system standard. The person
connecting the additional equipment to the signal input and output port is responsible for
whether the system complies with the IEC60601-1 standard.
Refer to the following chapters for the minimum value of patient physiological signals.
Operation of the device below the minimum value may result in inaccurate results.
The Monitor shall comply with the standard IEC 80601-2-30:Particular requirements
for basic safety and essential performance of automated non-invasive sphygmomanometers.
1.2 General Information
This device is defibrillator protected,the time of defibrillation recovery is 5 seconds.Note that no
precautions specific to the device is required during defibrillation, and defibrillation discharge has
To Next Page
Loading...
Need help?
General
