G10
27
finish a circle, the software will show the picture and have a beep sound.
But sometimes, you had finished the circle and the software show the circle,
software doesn’t transmit a beep sound and it doesn’t show “Record Horizontal” is
successful. It means some place of the circle doesn’t have enough data (You can check
it from the software), you should rotate it again in the place without enough data.
Figure 4-5
Second step is “Record Horizontal”. It’s almost same as step 1. The only difference is
this time the receiver is installed to the pole directly, just as the figure shows. Others
are same.
Figure 4-6
To Next Page
Loading...
