Girard Systems G2000 - Motor and Mounting Bracket Specifications; Cable Lengths and Control Box Specs; Remote Transmitter and Switch Specifications

54
Girard Systems © 2005
III. MOTOR SPECIFICATIONS
1. Type - Tubular with Manual Override
2. 120 VAC - 60 Hz
3. 12 RPM - 4-minute Maximum Run Time
4. 2 Amps - 240 Watts
5. 50 Nm
6. Thermal Protected
IV. MOUNTING BRACKETS
1. Height - 7-5/16"
2. Width
a. Outer Brackets - 19-1/2"
b. Center Bracket - 11-1/2" (over 18')
c. Center Bracket - 4" (14'–18')
V. CORD/CABLE LENGTHS
1. Awning Motor - Six (6') foot cord
2. Wind Sensor Anemometer - Six foot (6') cord
3. Wall Mount Rocker Switch (G-2000) - Ten foot (10') low-voltage cable
4. Wall Mount Paddle Switch (G-1500) - Ten foot (10') 120V/15amp cable
VI. CONTROL BOX SPECIFICATIONS
1. Input: 120 VAC - 50/60 Hz
2. Output: 120 VAC - 50/60 Hz; 1 phase; 3.0 FLA; 0.1 HP
VII. REMOTE CONTROL TRANSMITTER
1. Single Frequency - 433 Mhz
2. Lithium Battery - 12V/23amp
3. Frequency Range - 45 ft.
VIII. REMOTE RTS switch
1. Single Frequency - 433 Mhz
2. 3V Lithium Battery - 12V/23amp
3. Frequency Range - 65 ft.