41
Girard Systems © 2005
M. ANEMOMETER
(Hardware Installation Only)
1. Place anemometer on roof of vehicle in position shown (Fig. 26), ensuring that base is
pointing toward front of RV. Location should be
a. on and parallel to roofline of RV; and
b. near awning to ensure wind speed is measured at the awning. Guard against
installing anemometer near obstructions (air conditioner, storage pod, etc.).
2. Mark a hole location for cord insertion into RV, with placement directly below where cord
exits bottom of anemometer.
Figure 26
Anemometer (Wind Sensor) Placement on Roof of RV
To Next Page
Loading...
