7
Girard Systems © 2005
awning adjustment. If built-in motor shut off does occur, allow sufficient time for motor to
reset (up to one hour depending on outside temperatures). The manual override feature can
be used during this period.
b. The Wind Sensor V Controller and the Anemometer work together to continuously
monitor the wind speed around your awning at any given moment. If the actual wind speed
becomes greater than the wind speed setting of your controller, a two-second delay occurs
and a signal is sent to the awning motor to retract the awning. (The awning will remain in
the retracted position until such time that it is again extended by pressing the down
button on switch.)
Figure 1
Wall Mount (Rocker/PADDLE) Switch
To Next Page
Loading...
