Global Surgical SMR MAXI Standard User Manual

Section 2 Unpacking and Preparation for Use
2-2
TM
I
O
2.1. Pump Connections
1. Unlock and open the door of the pump compartment.
2. Cut the tape on each side of the pump as near to the wooden base board as possible.
3. Peel the tape away from the pump housing.
4. Remove the spacer board located between the pump and wooden base board.
5. Connect the power cord to a properly grounded receptacle.
6. Turn on the Pressure Pump and set the air pressure. See Section 4.8.3
7. Turn o󰀨 the Pressure Pump.
8. Turn on the Vacuum Pump and check that there is vacuum at the external vacuum hose.
9. Turn o󰀨 the Vacuum Pump.
10. Close and lock the pump compartment door.
WARNING
ELECTRICAL SHOCK HAZARD! CONNECT THE SMR MAXI CABINET ONLY
TO A PROPERLY-WIRED GROUNDED RECEPTACLE.
CAUTION
!
The pumps in the cabinet have been secured for shipment by tape. Before
operating them remove the tape. Failure to cut and remove the shipping tape
from around the two pumps will result in damage to the pumps.
CAUTION
!
The internal power receptacles located inside the cabinet are not for general use.
CAUTION
!
Do not place cabinet in location where access to wall plug is blocked.
Pump Compartment
Door
Lock
Wooden Base
Tape
Spacer Board
Cut tape here
on both sides

Global Surgical SMR MAXI Standard Specifications

General

Brand	Global Surgical
Model	SMR MAXI Standard
Category	Medical Equipment
Language	English