Global BEAT-Tr - Page 39

USER MANUAL
Range BEAT-Tr
Edition: January 2016
Revision: No. 3
MODE OF USE - 39
COMPULSORY
>CONTROL ISO 12176-3
Pressing START/VALIDATE key the current configura-
tion is showed.
CONTROL ISO 12176-3
<YES>/<NO>
<YES> corresponds to the identification according to ISO
12176-3 whereas selecting <NO> there is no observance.
Use the ¨ or § keys to shift from <YES> to <NO> or vice versa. Click the START /
VALIDATE key to accept the selection made. Click <STOP> to exit this option without
making a modification.
Finally, the latest option RESET allows to establishing the way to delete the operator’s
identification entered.
CONTROL ISO 12176-3
>RESET
Pressing START/VALIDATE key the current configura-
tion is showed.
RESET
<YES>/<NO>
<YES> the operator’s ID is deleted every time the unit
is switched off. <NO> with the change of date only.
Use the ¨ or § keys to shift from <YES> to <NO> or vice versa. Click the START /
VALIDATE key to accept the selection made. Click <STOP> to exit this option without
making a modification.
C JOB:
To modify the existing configuration of the option JOB, proceed as follows:
WARNING !
This option might have restricted access. If enabled, the following screen
will appear initially:
OPERATOR: Enter the supervisor PIN number.
Once the supervisor code has been introduced and the START/VALIDATE button pressed,
the following screen that is directly shown that not having the restriction enabled:
>SHOW
COMPULSORY
Pressing START/VALIDATE key the current configura-
tion is showed.
SHOW
<YES>/<NO>
<YES> corresponds to the job identification enabled
whereas <NO> to disenabled.
Use the ¨ or § keys to shift from <YES> to <NO> or vice versa. Click the START /
VALIDATE key to accept the selection made. Click <STOP> to exit this option without
making a modification.
The next option allows to establishing the obligation or not in carrying out the identifica-
tion.