4
Dear GlucoRx X6 System Owner
Thank you for choosing the GlucoRx X6 Multi-Functional Monitoring
System. This manual provides important information to help you to
use the system properly. Before you begin, please read the following
contents thoroughly and carefully. If you have other questions regarding
this product, please contact GlucoRx Customer Care or your place of
purchase.
Intended Use
This system is intended for use outside the body (in vitro diagnostic
use) to quantitatively measure the biochemical parameters - blood
glucose, β-ketone, lactate, total cholesterol, triglycerides and uric acid
- in whole blood. It is for home use or for healthcare professional use.
It should NOT be used for diagnosis or screening of diseases. Please
refer to the table below for what kind of whole blood sample* to obtain:
Home Use** Professional Use
Blood Glucose Capillary
Capillary/ Venous/ Arterial/
Neonatal
β-ketone Capillary Capillary/ Venous
Lactate Capillary Capillary/ Venous
Total Cholesterol Capillary Capillary
Triglycerides Capillary Capillary
Uric Acid Capillary Capillary
* All samples must be whole blood samples.
** Home users should only obtain whole blood samples from the
fingertips.
Test Principle
Your system measures the amount of blood glucose/ β-ketone/ lactate/
total cholesterol/ triglycerides/ uric acid (biochemical parameters) in
whole blood. The test is based on the measurement of electrical current
generated by the reaction of the individual biochemical parameters
with the reagent of the respective test strip. The meter measures
the current, calculates the biochemical parameters in the blood and
To Next Page
Loading...
