Glutz eAccess - Configuring the Buzzer; Configuring the LED; UID Mode

www.glutz.com
- 26 -
Device configuration
5.4 Configuring the buzzer
The buzzer can be activated, deactivated or activated for special cases.
Example:
If the buzzer is permanently activated, it will sound for every identication, any programming and any
error.
The brightness of the LEDs on the devices can be congured.
Example:
In a dark environment, it is not necessary to have the LEDs on full brightness as they are easily visible.
5.5 Configuring the LED
5.6 UID Mode
This conguration allows you to set whether a device is able to work with UID media or not.
Example:
Only Glutz media should be authorised for a secure area, with UID media also being permitted for the
remaining areas.
NOTE
Reduced security
In UID mode, the transfer of RFID data is unencrypted.
Configuration Card order
Buzzer switched on +730+
Buzzer completely deactivated +731+
Buzzer switched on, except for successful identification +732+
Configuration Card order
LED off +750+
LED minimal brightness +751+
LED normal brightness +752+
LED maximum brightness +753+
Configuration Card order
UID mode on/off +850+/-850-