Glutz eAccess - Keypad: Fixed Code Length; Battery Type (Security Plate Only)

- 27 -
Device configuration
The code length for E-reader devices can be set with a maximum of 8 digits.
Example:
If the device is not set to have a xed code length, the OK key must be pressed after the entering code.
For security ttings, automatic battery type recognition takes place when the device is started. This only
works for lithium batteries when new batteries are inserted.
At the end of the start up signals, this will be indicated by a specic tone sequence. If this does not corre-
spond with the respective battery type, it will have to be manually congured.
Konfiguration Kartenfolge
None, always confirm code with OK +880+
maximum 2-digit codes +882+
maximum 3-digit codes +883+
maximum 4-digit codes +884+
maximum 5-digit codes +885+
maximum 6-digit codes +886+
maximum 7-digit codes +887+
maximum 8-digit codes +888+
TIP
Maximum length
If the device is configured for codes with a maximum of 8 digits, this does not mean that 8-digit codes are
mandatory; shorter, but not longer, codes can be programmed.
5.7 Keypad: fixed code length
5.8 Battery type (security plate only)
Battery type Signal
Lithium batteries ‘Smoke on the water’
Alkaline batteries ‘Beethoven’s Fifth’
Manual configuration Card order
Lithium batteries +891+
Alkaline batteries +893+