GME XRS-330C - Scanning; Scan Groups

XRS-330C
20
To recall a priority channel:
Briey press the PRI key. The radio will immediately switch to the Priority channel
and the ‘PRI’ icon will be displayed.
NOTE: If the radio was scanning when the Priority channel was recalled, the scan
will be cancelled.
SCANNING
Your radio incorporates a scan function allowing selected groups of channels to be
scanned for signals. Channels can be scanned at a rate of 50 channels per second.
When a signal is found, scanning will pause to allow the signal to be heard then
resume scanning when the channel is clear again.
SCAN GROUPS
Your radio supports three scan groups:
• Open Scan: Allows you sequentially scan from 2 to 80 user-selectable
CB channels.
• Priority Scan: Allows you constantly monitor your priority channel
while scanning a group of user-selectable CB channels.
• Network Scan: Allows a group of radio users to maintain
communications even when the band is congested by monitoring
a small group of user selectable channels. If the operating channel
becomes busy with users from outside your group, Net-Scan will
automatically select a new free channel from the scan group and
transparently switch all users in your group to the new channel.
To select open scan/priority scan/network scan:
1. Press the MENU key.
2. Navigate to select SCAN SETTINGS, and the required scan option.