GMI GT series - Service Due Date

3-8
OPERATING PROCEDUREUSER HANDBOOK
To proceed with the switch-off sequence.
• Press and hold both the LH button and the RH button
simultaneously.
3.7 SERVICE DUE DATE
The Service due date can be set by the workshop and is set to two
(2) years by default from last service date. The date can be set over
a period of 1 to 36 months in 1 month steps.
Note : The service due date will not normally be displayed at
start up but if display is selected, it will be shown at 90
days prior to the preset date, as shown in Fig. 3.15.
The SERVICE DUE feature has ve (5) congurable options:
1. Service Due Date message is not displayed (Default).
2. Service Due Date and overdue date messages are displayed,
as shown in Fig. 3.18.
Fig. 3.18 Service Due Date
The screen, shown in Fig.
3.19, is displayed when the
Service date has expired.
i.e. overdue.
After approximately five
seconds, the instrument
warm-up continues.
Fig. 3.19 Service Overdue