28
R6530 DVD Recorder
:: Timer Recording
You can program up to 8 Timer Recording events up to 1 year in advance. Before you begin:
• Turn on the DVD Recorder using the front panel Power button. If the unit is in Standby mode, press On/Standby on the remote control to
power on the unit. The green Power indicator will glow on the front panel display.
• Turn on your TV, and set it to the video input connected to the DVD Recorder.
• Turn on your audio system (if using an external amplifier/audio system), and set it to the input connected to the DVD Recorder.
• If you are Timer Recording from an external source, make sure that source is powered on and cued to the correct playback position.
• If you are recording from a cable box, make sure it is set to the right channel.
1 Press Open/Close on the remote control or front panel to open the disc tray.
2 Insert a DVD+R or DVD+RW into the disc tray.
• If you are using a DVD+R, it must be not be finalized. Once a DVD+R is full or finalized, it can-
not be recorded on again.
3 The unit will take a few moments to read the disc and then switch to Disc mode automatically.
4 The disc menu for the DVD+R or DVD+RW will appear.
• Make sure the disc has sufficient free space for the show you wish to record.
5 Press Setup on the remote control.
6 Use the / buttons to select Timer Recording, and then press Play /Enter.
7 Use the / buttons to select any available event number (1-8) and press Play /Enter.
8 Set event details:
To Next Page
Loading...
Need help?
General
