Godwin HS80 - HANDBOOK Issue

OPERATOR Book No.: 95-0014-0000/A
HANDBOOK Issue: 06
Page 22 of 30
Align the guide pin lip with the centre boss of the impeller
(Figure 24).
Figure 24 Aligning the guide pin lip with the centre boss of the impeller
Hold the lip tip firmly against the centre of the impeller boss
and tighten the cap screw with Allen wrench until it is held in
place (Figure 25).
Figure 25 Tightening the cap screw with Allen wrench
Place the complete assembly into a vice and then tighten the
cap screw using a torque wrench (Figure 26) to the correct
torque. Check cap screw size and see Technical data section
for detail.
Figure 26 Tightening the cap screw with torque wrench