Book No.: 95-0014-0000/A OPERATOR
Issue: 06 HANDBOOK
Page 3 of 30
1 INTRODUCTION
The purpose of this Installation, Operating and Maintenance Handbook is to provide the owner or user of the equipment
with sufficient information to carry out those tasks on the Heidra hydraulically driven range of vertical suction
Submersible Pumps.
Pump models covered: -
HS80 HS103 HS150V-SG HS250
HS100 HS150 HS150HH HS300
HS100NC HS150NC HS200
HS100-SG HS150V HS200-SG
Because this handbook covers so many variants the user must ensure that they are reading the correct diagrams and
instructions for the unit they are working on.
Installation and maintenance is designed to be carried out using simple hand and service tools. A range of special tools
designed to ease dismantling and reassembly is available from Xylem Dewatering Solutions. When the user has
insufficient tools, experience or ability, this work should not be attempted. Under no circumstances should makeshift
tools or equipment be used, as this may adversely affect safe working practices and pump operation.
Ensure that suitably qualified personnel carry out the installation. The variety of conditions and environments in which
this equipment can be used means that the operator and those responsible must satisfy themselves as to the safety
and acceptability of each application and operating condition of this equipment. Under no circumstances will Xylem
Dewatering Solutions be responsible or liable for indirect or consequential damages arising from the use or application
of this equipment.
The pump may be supplied with or without a hydraulic motor fitted. This handbook covers the pump end only. For
packaged pump sets, information on equipment other than the pump end is contained in separate documentation.
Parts that have not been approved by Xylem Dewatering Solutions cannot be relied upon for correct material,
dimensions or finish. Xylem Dewatering Solutions cannot therefore be held responsible for any damage arising from the
use of such parts. This and failure to observe any instruction or procedure in this handbook will invalidate the warranty.
The information contained in this handbook was correct at the time of publication. It is subject to amendment at any
time. Should any doubt exist about the veracity of the information, contact Xylem Dewatering Solutions for clarification
before proceeding.
Associated Publications: - 95-0014-0000/B Operator handbook – Heidra Power Packs.
2 HOW TO USE THIS HANDBOOK
Read this section before installing, operating or carrying out any maintenance on the unit.
When the pump is being installed operated or maintained there are a number of practices that may lead to personal
injury or product damage. Your attention is drawn to the following symbols used throughout this handbook.
CAUTION. This caution symbol draws attention to special instructions or procedures which, if not correctly
followed, may result in damage to, or destruction of equipment.
WARNING. This warning symbol draws attention to special instructions or procedures which, if not strictly
observed, may result in personal injury.
WARNING. A WARNING SYMBOL WITH THIS TYPE OF TEXT DRAWS ATTENTION TO SPECIAL
INSTRUCTIONS OR PROCEDURES WHICH, IF NOT STRICTLY OBSERVED MAY RESULT IN SEVERE
PERSONAL INJURY, OR LOSS OF LIFE.
NOTE: -
A note is used to draw your attention to additional important information.
To Next Page
Loading...
