Gooxi SR201 2U User Manual

41
5
Appendix
Common fault diagnosis:
No display after power on
 Make sure the monitor cable is fully seated and that the monitor's
power light is on when the monitor is powered on
 Make sure the monitor is connected to the server
 If the above operation does not solve the fault problem, it is
recommended to replace the known correct monitor to confirm
whether the original monitor is faulty
 If there are no problems, please contact Gooxi technical team to
solve the problem
Warning light on the front panel
 Please confirm the specific alarm information of the alarm LED
according to the instructions of the front panel LEDs and buttons in
the manual
 The power failure LED warning, please check whether the LED of
the power module on the rear window of the server is abnormal.
-If the LED of the power module is normal, please contact Gooxi
technical end to solve the problem
-If the LED of the power module is abnormal, please confirm
whether the server & power module & power cord are working
normally
 The system alarm LED warning, please check the external
environment first
 Other LED alarming, please contact Gooxi technical end to solve the
problem
Hard disk LED is abnormal
 Make sure the hard drive is installed properly.
 Please confirm the specific alarm information of the alarm LED
according to the instructions on the rear panel LEDs and buttons in
the manual
 Please confirm whether the Raid card is configured correctly
 Install the OS to confirm whether there is a phenomenon of hard disk
failure. If there is such a phenomenon, please contact Gooxi
technical team to solve it
Raid card cannot be used
 Make sure that the Raid card assembly is in place
 Re-insert the Raid card & PCIe adapter card to confirm whether it
can work normally
 Please replace the Raid card that is known to be available. After
troubleshooting the problem of the card itself, it still cannot work

Gooxi SR201 2U Specifications

General

Brand	Gooxi
Model	SR201 2U
Category	Server
Language	English