COMPLETE THIS STEP
VERTICAL SUPPORT
AND 2)
FIRST. (SEE SUB-STEPS 1
SUPPORT
PICNIC TABLE
2 X 4 X 15"
2 X 4 X 30"
PICNIC TABLE
2-1/2" WOOD SCREW
ROCK WALL REMOVED FOR ASSEMBLY CLARIFICATION
STEP 37: PICNIC TABLE
2 X 4 X 15"
PICNIC TABLE
SUPPORT
3: FASTEN THE ASSEMBLY CREATED FROM THE PREVIOUS TWO STEPS TO THE CORNER POST. POSITION THE ASSEMBLY
SO THAT THE PICNIC TABLE SUPPORT IS ON THE OUTSIDE OF THE CORNER POST, AND THE VERTICAL SUPPORT IS ON
THE INSIDE OF THE 2 X 6. FASTEN THE ASSEMBLY TO THE UNIT WITH THREE 2" WOOD SCREWS IN THE PICNIC TABLE
SUPPORT, AND TWO 2-1/2" WOOD SCREWS IN THE 2 X 6 AT THE BOTTOM. (SEE PATTERN BELOW)
TO THE NEXT STEP.
ACCOMODATE OPPOSITE SIDES OF THE PICNIC TABLE. MAKE SURE THE ASSEMBLY IS SQUARE BEFORE PROCEEDING
BELOW. MAKE SURE TO ASSEMBLE THE THE PICNIC TABLE SUPPORT AND THE PICNIC TABLE VERTICAL SUPPORT TO
1: PLACE THE 2 X 4 X 15" PICNIC TABLE SUPPORT ON TOP OF THE 2 X 4 X 30" PICNIC TABLE VERTICAL SUPPORT AND
POSITION THE BOARDS AT A RIGHT ANGLE.
2: ENSURE THAT THE PICNIC TABLE SUPPORT AND THE PICNIC TABLE VERTICAL SUPPORT ARE SQUARE AND FASTEN
THE PICNIC TABLE SUPPORT TO THE VERTICAL SUPPORT WITH THREE 2 1/2" WOOD SCREWS IN THE PATTERN SHOWN
2 X 4 X 30"
PICNIC TABLE
VERTICAL SUPPORT
To Next Page
Loading...
