Gotop RigiScan Plus - Chapter 6: Rigiscan Plus Reports

-51-
Chapter 6: RigiScan Plus Reports
6.1 The Session Scan Summary Report
The RigiScan Plus Session Scan Summary Report allows you to see the results of previously download-
ed sessions. These are the elds that appear on the Session Scan Summary Report.
Patient ID. This eld displays the identication number of the patient you selected on the Session
Scan Summary screen.
Visit Date. This eld shows the visit date you selected on the Session Scan Summary screen.
Comments. This eld displays any comments you entered when you initialized the monitor.
Session. This eld displays the session numbers for the current patient’s record. C represents a char-
acterization session, and 1, 2, and 3 represent subsequent sessions.
Date. This eld displays the date, start and stop times and the duration of each session.
Number of Events. This eld displays the total number of qualied events recorded during each
session.
Baseline Tumescence. This eld shows the baseline, or accid circumference for penile base and tip.
Average Event Rigidity. This eld shows average rigidity during qualied events for the base and
the tip measured as a percentage.
Sustained Erectile Activity. These elds show the Rigidity Activity Unit (RAU) and Tumescence
Activity Unit (TAU) measurements during qualied events for base and tip data. The RAU value rep-
resents the area under the rigidity curve during an event. The TAU value represents the area under the
tumescence curve based on the percent increase in tumescence over baseline during an event. Refer
to the Glossary for information on how these values are calculated.