Installation
3A3489T 13
v
5. Connect the blast hose, hose restraints, control
hoses, and coupler pins.
Connect the Water Supply
1. Connect to a water supply hose with a minimum ID
of 3/4 in. (19 mm) to the garden hose connection on
the pump inlet.
NOTE: The maximum water supply pressure is 100 psi
(6.8 bar, 0.68 MPa). The minimum flow requirements is
3 gpm (11 lpm).
Failure to fully secure the blast hoses may cause
hoses to detach during operation. To help prevent
serious injury from flying debris, always install the
blast hose restraints and coupler pins.
NOTICE
Do not use a wrench when installing the nozzle.
Damage to the seal could occur. To avoid seal
damage, always hand-tighten the nozzle.
WLF
WLE
WLD
To Next Page
Loading...
Need help?
General
