Operation
16 3A4802D
Using the Wash Feature
The wash feature uses water (without abrasive) to rinse
areas that have been blasted with abrasive.
1. Close the abrasive ball valve (M).
2. Turn the selector valve to WASH.
3. Blast 1-2 minutes until the abrasive is cleared from the
hose.
4. The equipment is now ready to wash any previously
blasted surfaces.
NOTICE
There will always be some residual abrasive in the blast
hose. Never use the wash feature on any surface other
than where you have blasted, or intend to blast. It can
affect /dull the surface.
To Next Page
Loading...
Need help?
General
