Priming
12 3A1177B
Priming
For flushing storage fluid and loading pump and hose
with paint.
Before priming sprayer, follow Cleaning procedure, Steps 1-6,
page 16.
1. Turn OFF power switch.
2. Submerge suction tube in paint.
3. Turn Prime/Spray valve to PRIME.
4. Point gun into waste pail.
5. Push pump priming button two times.
6. Turn ON power switch. Align arrow on sprayer and
bucket symbol on pressure control knob.
7. When paint, without bubbles, starts to come out of
prime tube, trigger gun and turn Prime/Spray valve
to SPRAY. When paint comes out of gun, release
trigger.
NOTE: The motor stopping indicates the pump and
hose are primed with paint.
8. Transfer prime tube to paint pail.
ti2018a
ti2026a
ti2019a
ti2027a
ti15972a
ti2028a
ti2029a
ti2030a
To Next Page
Loading...
Need help?
General
